ADAAG, Americans With Disabilities Act (ADA) Consulting

Back to previous page, ADAAG Figures Displayed by Element

After viewing each image you must use your BACK key to return to this list

Stairs

Figure 18a -- Usable tread width and examples of acceptable nosings, flush riser
Figure 18b -- Usable tread width and examples of acceptable nosings, angled riser
Figure 18c -- Usable tread width and examples of acceptable nosings, rounded riser
Figure 19a -- Stair handrails, plan
Figure 19b -- Stair handrails, elevation of center handrail
Figure 19c -- Stair handrails, extension at bottom of run
Figure 19d -- Stair handrails, extension at top of run
Figure 39a -- Size and spacing of handrails
Figure 39b -- Size and spacing of handrails
Figure 39c -- Size and spacing of handrails
Figure 39d -- Size and spacing of handrails




Disclaimer
Every attempt has been made to create accurate reproductions of the Federal Register ADAAG figures. These drawings should only be used for reference. For complete technical standards obtain a copy of the Federal Register listed below.


The files differ from the Federal Register figures in the following ways:
Drawings of people were not reproduced.
Metric equivalencies were not included.
A few additional dimensions were added for clarification.
The ADAAG Standards for Accessible Design were published in the Federal Register / Vol. 56, No. 144 / Friday July 26, 1991 / Part III / 28 CFR Part 36 / Pages 35605 through 35691.

If you find any problems with the drawings please contact us. E-mail



Graphics Home Page


This Web Site Provided by Access by Design ---- E-mail