ADAAG, Americans With Disabilities Act (ADA) Consulting

Back to previous page, ADAAG Figures Displayed by Element

After viewing each image you must use your BACK key to return to this list

Doors

Figure 24a -- Clear doorway width and depth, detail
Figure 24b -- Clear doorway width and depth, hinged door
Figure 24c -- Clear doorway width and depth, sliding door
Figure 24d -- Clear doorway width and depth, folding door
Figure 24e -- Clear doorway width and depth, maximum doorway depth
Figure 25a -- Maneuvering clearances at doors, front approaches - swinging doors
Figure 25b -- Maneuvering clearances at doors, hinge side approaches - swinging doors
Figure 25c -- Maneuvering clearances at doors, latch side approaches - swinging doors
Figure 25d -- Maneuvering clearances at doors, front approach - sliding doors and folding doors
Figure 25e -- Maneuvering clearances at doors, slide side approach - sliding doors and folding doors
Figure 25f -- Maneuvering clearances at doors, latch side approach - sliding doors and folding doors
Figure 26 -- Two hinged doors in series
Figure 7c -- Accessible route, changes in level
Figure 7d -- Accessible route, changes in level




Disclaimer
Every attempt has been made to create accurate reproductions of the Federal Register ADAAG figures. These drawings should only be used for reference. For complete technical standards obtain a copy of the Federal Register listed below.


The files differ from the Federal Register figures in the following ways:
Drawings of people were not reproduced.
Metric equivalencies were not included.
A few additional dimensions were added for clarification.
The ADAAG Standards for Accessible Design were published in the Federal Register / Vol. 56, No. 144 / Friday July 26, 1991 / Part III / 28 CFR Part 36 / Pages 35605 through 35691.

If you find any problems with the drawings please contact us. E-mail



Graphics Home Page


This Web Site Provided by Access by Design ---- E-mail